How To Work With Reclaimed Wood
And finally make sure you clean your wood on a sunny dry day.
How to work with reclaimed wood. Always remember that whenever you want to work with reclaimed wood is the difficulties that you will be facing when the wood are embedded together with pieces of metal. If you dont need to show all sides of the reclaimed wood you may want to consider having at least one side milled down. Remove all nails screws staples rocks.
Wood dries much better in the sunshine and you dont want wood to stay damp for long as this can cause warping. As a reclaimed wood dealer we can work with you to find the perfect wood for your home. That is why reclaimed wood can be very precious.
Reclaimed Wood Wall Materials In addition to the materials youll need to install the wall panels themselves youll also need the following to work with any outlets or switch plates in the design. Visually inspect the wood. If there is a nail or staple in your wood it will damage the blades and you will have to buy new ones.
In order to handle the above situation you need to get the wood close in dimensions that are close to your requirements and it need to be surface plan according to certain size. Tape measure Sharpie or. Milling the wood is what generally makes it flat and square although if you only get one side milled down it will be flat but doesnt necessarily make it square.
You can also use a high-pressure water sprayer but youll need to be extra careful or you could damage the grain. Use a hand sander to sand all sides of the wood. From Doodlecraft Blog Continue to 9.
Then switch to the extra-fine sanding block to knock down any rough spots. Look for problem areas. Set Up Your Work Station Put your reclaimed wood onto sawhorses or use something else to hold them above the ground and level.