How To Use A Table Saw Correctly

Carefully switch out your circular blade for the diamond saw blade.

How to use a table saw correctly. Always set the length to be cut with a measuring tool and then line the mark up by eye. After youve switched out the blades put on safety gear. Turn on the saw and firmly hold the work piece to the miter gaugesled.

Dont forget to remove the blade stabilizer and washer if you were using with your table saw blade. When you get near the end of the board use a push stick to push the rest of the board through. Learn how to use your tablesaw safely and effectively.

Invest in a diamond blade. Stand to the side of and not directly behind the blade as youre ripping. By removing the motor you will get more space for cleaning and lubing inside of the table.

The most basic function of the table saw is ripping boards and making crosscuts. Push the board through the blade at a slow and steady rate keeping the board flush with the fence. We also review table saw safety and give yo.

Fit the appropriate rip blade into the blade arbor located at the top of the table and this should be after unplugging your table saw from the main power source. As you have already table saw without its shell it is easy to get access to the motor. Use a table or other outfeed support to hold the board as it leaves the saw.

To do this use the arbor nut wrench that came with your table saw to loosen the arbor nut the nut that holds the blade in place and position the rip blade with the teeth facing the front of the. This will cause binding and is dangerous. Dont wear baggy clothing and always we cant stress this enough wear safety glasses.