How To Turn Spindles On A Wood Lathe

Turn out the middle with a small gouge leaving a flat-bottomed recess ¼ deep.

How to turn spindles on a wood lathe. They then split that section of the trunk into usable sized billets in a process called riving A froe the edged tool with the wooden handle at right is used to rive wood. Conclusion You can often limp through turning one long spindle using a skew and the hand wrapped around the work trick. The roughing gouge is a very versatile gouge but it must be used.

One way is to use the headstock and the rear spindle to suspend a piece of wood between the two and turn along the length of the piece of wood. Install the aluminum fingers onto the ends of the wood blocks securing them in place with the 1 10-40 bolts and lock nuts. When turning spindles I like to cut a crosshatch into the ends of the turning blank so the workpiece centers quickly and seats solidly on the lathe.

The board attached to the Tenon Cutter rest against the bed of the lathe and provides support while cutting the tenons. Widen the groove to prevent the tool from grabbing. Turn on the lathe and gently probe the chisel into one end of the spindle blank.

Start at one end and remove the corners Photo 10a. If you switch from a thick tool like a spindle roughing gouge to a thinner tool like a skew you will need to raise the tool rest. Unless curly the bole is clear wood because there are no emanating branches that cause a knot.

Keep working your way along the spindle removing the corners from a square portion of the blank toward a rounded portion. This is referred to as spindle turning and is the type of woodturning that is done to create long ornate table legs and other long wood turnings. With the spindle and machine set up complete youre ready to cut woodUsing a spindle gouge and holding the chisel approximately parallel to the floor gently probe the tip of the chisel into the spinning spindle.

Prepare a spindle of appropriate length. Use the square-end tool to turn a ¼-inch groove in the back of the blank leaving a ⅜ outer rim of wood. The tenons were cut by mounting the blanks in the Spigot Jaws of the chuck and running the lathe at a very slow speed.