How To Polish Paint After Wet Sanding

Use a buffer and rubbing compound to polish the area.

How to polish paint after wet sanding. Fill a bucket with water and a small amount of soap cut your sandpaper sheet in two halves hold it horizontally and cut a vertical line right in the middle. Be sure your surface is clean and dry remove all contaminants Use only when temperatures range between 50F and 90F where relative humidity is below 85 Begin and finish spraying off the object using a side-to-side sweeping motion overlapping your spray slightly with each pass Paint can be recoated within an hour Paint fully cures in 24 hours. Whether you need to polish your car to get rid of Orange Peel o.

I also use the 3M foam polishing pads with the sculpted surface. Essentially wet sanding is the process of sanding a car with water. Allow the surface to dry.

If you cut your sandpaper correctly it will fold in three equal parts. Trying to get the surface flat with 1500 paper is a challenge. Eventually the orange peel and finer scratches in the clear coat will remove easily by wet sanding.

The water acts as a lubricant and vehicle to remove the paint dust that would normally just clog up the sandpaper and get in the way. Water or some liquid is used as lubrication to carry away grit particles stuck on the surface after you dry sand it. This video will show you how to wet sand and polish your vehicle after spray paintingHow To Wet Sand and Polish After Spray Painting CarPlease Shop and see.

Tutorial video on how to wet sand paint to achieve a high gloss finish remove any imperfections in the paint surface remove orange peal and achieve a mirr. Always pre-soak the sandpaper ensure the area is wet and work evenly across the surface. Use 400-grit sandpaper is great for wet sanding clear coat off car surface.

With a single-stage paint youll notice the color of the paint in the sanding residue which is normal. If this was a two-stage paint you would only be sanding the clear coat and the water will only turn milky. Once the wet sanded area is completely dry apply some rubbing compound to a buffer pad and use a power buffer to polish the.