How To Make Lathe Tool Handles

This needs to be a press fit.

How to make lathe tool handles. Now youre ready to mount the tool to your new handle. Ad Easy to Use - Laser Fits in Spindle 4-Axis 00002 resolutn Fast Setup. To assemble the tool you absolutely want to have the ferrule in place before setting the tool in the handle.

Wood blanks for tool handles may be purchased or you can use whatever convenient hardwood you have available. The next part was the most difficult. It amounts to turning a spindle drilling a hole to accept the tool and then using epoxy to hold it in place.

-use a piece of copper pipe as a ferrule when the tool inserts into the wood handle. It is standard practice to add a ferrule or the equivalent for extra strength where the tool joins the handle. Its a fairly simple matter to make a wooden handle.

A file on it with the lathe run-ning about 1000 rpm. The tool should be a tight fit but a few drops of epoxy glue will insure it wont come loose. For this size tool you would have a terribly hard time fitting the ferrule over the business end since it is substantially larger than the ferrule.

Many quality tools these days come without a handle. There should be little or no ghosting at the ferrule end. Put on a full-face shield and set the lathes speed between 400 and 600 rpm.

This helps reduce the cost and allows you to make a handle that is customized for you. Put the bit against the handle into the hole from the center and turn the lathe on slow speed. Ad Easy to Use - Laser Fits in Spindle 4-Axis 00002 resolutn Fast Setup.