How To Clean Raw Wood After Sanding
It has been a woodworkers tool for a long time.
How to clean raw wood after sanding. The most important part of finishing a piece of furniture happens before you open a can of stain or paint it starts with the sanding. Wipe With Denatured Alcohol Many woodworkers end the wood preparation step with the tack-cloth wipe-down but for the very best results conclude your preparation by wiping down the surfaces with a clean cloth moistened with denatured alcohol. Whether youve just installed a wood floor or added some fresh trim to your windows or doorways or even built a craft or furniture piece from scratch you may find yourself in a situation where the unfinished wood needs cleaning but you want to use something that wont affect.
They are very handy if you need to de-grease anything. Wash Down Sealed or Painted Wood If the mold has grown on painted wood like an interior door or a sealed wood finish like floors begin by washing down with a liquid dishwashing detergent and water solution. Before doing anything else with your woodwork rub a tack cloth over the entire surface of the wood to remove the dust and residue.
It also attracts and picks up the finest dust particles and gathers them on the rag. Stir the contents of the can every time you open it. Using denatured alcohol after sanding would work too.
Then switch to fine sandpaper 200 grit until the entire piece is uniform. This is a water-based sealant that brushes on easily and never leaves streaks. Allow the dampened wood to dry 30 minutes before the final sanding.
The mineral spirit evaporates fast without posing any threat to the wood. Mix one tablespoon of detergent to one quart of water. Once youre done sanding your woodwork there may be some residue left over.
Always see to it that you will be sanding along the wood grain. Clean unfinished wood with a damp rag before staining. Use a good vacuum and then a tack rag to wipe the surface clean of any contaminants.